1. Universal turning parts are fault parts. Grease should be replenished in time, wear should be checked frequently, and repaired and replaced in time. The fleet should have a spare cardan shaft assembly to ensure recovery in a few minutes in the event of a failure.

2.確保液壓油清潔。自上料微型攪拌車的工作環境不好，必須防止臟的水泥砂進入液壓系統。應按手冊要求定期更換液壓油。一旦檢查發現水或沙子混入了液壓油中，則必須立即停止液壓系統并更換液壓油。

2. Make sure the hydraulic oil is clean. The working environment of self feeding Mini mixer is not good, so it is necessary to prevent the dirty cement sand from entering the hydraulic system. The hydraulic oil should be changed regularly according to the manual. Once water or sand is found mixed in the hydraulic oil, the hydraulic system must be stopped immediately and the hydraulic oil must be replaced.

3.確保液壓油冷卻裝置有效。定期清潔液壓油散熱器，以防止散熱器被水泥堵塞，檢查散熱器風扇是否正常運行，并防止液壓油溫度超過標準。只要液壓元件確保液壓油清潔，通常幾乎不會發生故障，但是制造商的使用壽命不同。

3. Ensure that the hydraulic oil cooling device is effective. Regularly clean the hydraulic oil radiator to prevent the radiator from being blocked by cement, check the radiator fan for normal operation, and prevent the hydraulic oil temperature from exceeding the standard. As long as the hydraulic components ensure that the hydraulic oil is clean, there is usually almost no failure, but the service life of manufacturers is different.

通常，如果驅動器由于故障而停止工作，則混凝土罐將無法正常旋轉，這將導致車輛中的混凝土報廢，甚至整個罐中的混凝土也會在罐中凝結，從而導致全自動自上料攪拌車報廢。因此，驅動裝置是否可靠是使用中必須高度重視的問題。

Usually, if the driver stops working due to failure, the concrete tank will not rotate normally, which will lead to the scrapping of concrete in the vehicle, and even the concrete in the whole tank will coagulate in the tank, resulting in the scrapping of the concrete mixer. Therefore, whether the driving device is reliable or not is a problem that must be attached great importance in use.

自上料微型攪拌車堵塞處理步驟

Processing steps for blockage of self loading Mini mixer

設備本身的特性，自上料微型攪拌車廣泛用于各種建筑物。長時間使用設備時，設備不可避免會出現不同的故障問題。其中，阻塞很常見，因此，當設備出現此類問題時，我們應如何合理處理？

Due to the characteristics of the equipment itself, self loading Mini mixer is widely used in various buildings. When the equipment is used for a long time, the equipment will inevitably have different fault problems. Among them, blocking is very common, so when the equipment has such problems, how should we deal with them reasonably?

1.每次充電前，請用水沖洗進水口，以在進水期間保持進水口濕潤。

1. Before charging each time, please flush the water inlet with water to keep the water inlet moist during the water inlet period.

2.裝載時，將裝在車輛上的清洗水箱注滿水。

2. When loading, fill the washing water tank on the vehicle with water.

3.充電后，沖洗進料口并清潔進料口附近的混凝土。

3. After charging, flush the inlet and clean the concrete near the inlet.

4.在施工現場卸貨后，沖洗卸料斜槽，然后向混凝土儲罐中添加30-40L的洗滌水；在車輛返回過程中，保持混凝土儲罐緩慢旋轉。

4. After unloading at the construction site, flush the discharge chute, and then add 30-40l washing water to the concrete storage tank; during the return of vehicles, keep the concrete storage tank rotating slowly.

5.請記住在下一次裝載之前將混凝土儲罐中的污水排干。

5. Please remember to drain the sewage from the concrete storage tank before the next loading.

6.每天徹底清潔混凝土儲罐以及機器周圍的入口和出口。自上料微型攪拌車的清潔點可確保沒有水泥和混凝土結塊。

6. Thoroughly clean the concrete storage tank and the entrance and exit around the machine every day. The cleaning point of the self loading Mini mixer ensures that there is no cement and concrete caking.