自動混凝土攪拌車的高噪聲高溫原因

 來源:http://www.hu198.com 日期:2022-04-14 發布人:admin
在設備的實際操作中,自動進料攪拌機的傳動也是非常重要的部分。因此,在使用過程中需要對其油質進行一定程度的檢查,如何進行操作?
In the actual operation of the equipment, the transmission of automatic feeding mixer is also a very important part. Therefore, in the process of use, it is necessary to check the oil quality to a certain extent. How to operate?
1.將小型混凝土攪拌運輸車停在水平地面上,并擰緊手剎。
1. Park the small concrete mixer truck on the horizontal ground and tighten the hand brake.
2.讓發動機怠速運轉幾分鐘。
2. Let the engine idle for a few minutes.
3.踩下制動踏板,將操縱桿移至倒檔,前進檔等,并在每個檔中停留幾秒鐘,以向液壓變矩器和所有換檔執行器注滿液壓油。將操縱桿移至停車位置。
3. Press the brake pedal, move the control lever to reverse, forward, etc., and stay in each gear for a few seconds to fill the hydraulic torque converter and all shift actuators with hydraulic oil. Move the lever to the park position.
4.從加油管中拉出自動變速箱油尺,將所有清潔過的油尺插入加油管,然后拉出,并檢查油尺上的油位。
4. Pull out the automatic transmission oil dipstick from the oil filler pipe, insert all cleaned oil dipsticks into the oil filler pipe, then pull out, and check the oil level on the oil dipstick.
在檢查自動供料混合器的傳動裝置或?qū)鲃友b置進行故障排除之前,請先檢查傳動裝置的油位和質量。將換檔器置于P檔,并使發動機怠速運轉至少幾分鐘,機油達到正常工作溫度,并且汽車需要停在水平道路上,以確保差速器和變速箱油之間的油位高。傳輸正常,穩定。
Before checking or troubleshooting the transmission of the automatic feeding mixer, please check the oil level and quality of the transmission. Place the shifter in P gear and allow the engine to idle for at least a few minutes, the oil reaches the normal operating temperature, and the car needs to stop on a level road to ensure a high oil level between the differential and the transmission oil. Transmission is normal and stable.
在炎熱的夏天,混凝土自動裝料攪拌機的內部噪音和溫度會增加。夏季溫度不高,但這可能是由于發動機或汽車中機油的溫度所致。
In hot summer, the internal noise and temperature of the automatic concrete loading mixer will increase. The temperature is not high in summer, but this may be due to the temperature of oil in the engine or car.
1.洗車水箱中的水量不足以清理干凈。向洗車水箱注滿水。
1. The amount of water in the car washing water tank is not enough to clean up. Fill the car wash water tank with water.
2.如果吸管的進氣口堵塞或堵塞,可以檢查并擰緊吸管。不要呼吸空氣。
2. If the air inlet of the straw is blocked or blocked, check and tighten the straw. Don't breathe air.
3.油箱液位過低,并且油液中的空氣被吸入泵中。如果發生這種情況,您可以添加帶有相同標簽的液壓油。
3. The liquid level in the oil tank is too low, and the air in the oil is sucked into the pump. If this happens, you can add hydraulic oil with the same label.
4.如果泵的安裝支架不夠牢固,則在工作期間會產生振動和噪音。在這種情況下,可以加固油泵支架。
4. If the mounting bracket of the pump is not firm enough, vibration and noise will be generated during operation. In this case, the oil pump support can be reinforced.
5.堵塞的濾芯會使吸油困難或不充分。在這種情況下,請清潔濾芯或更換濾芯。
5. Blocked filter element will make oil absorption difficult or insufficient. In this case, clean the filter element or replace the filter element.
6.油冷卻風扇未打開。卸下:打開冷卻風扇。
6. The oil cooling fan is not turned on. Remove: turn on the cooling fan.
7.如果液壓油不符合要求或油太粘,請更換符合標簽要求的低粘度液壓油。
7. If the hydraulic oil does not meet the requirements or the oil is too viscous, please replace the low viscosity hydraulic oil that meets the label requirements.
8.儲罐中有堅硬的混凝土。如果發生這種情況,請及時清理并鏟起。
8. There is hard concrete in the tank. If this happens, please clean and shovel it in time.
9.輸入萬向節軸之間的連接角度以及萬向節軸與取力器之間的連接角度太大,如果松開會產生噪音,在這種情況下,請在時間內檢查并擰緊。
9. The connection angle between the input universal joint shaft and the connection angle between the universal joint shaft and the power take-off is too large. If it is loosened, it will produce noise. In this case, please check and tighten it within a time.
以上就是為大家介紹的有關自上料混凝土攪拌罐車多少錢的詳細介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://www.hu198.com/
The above is a detailed introduction about the cost of self loading concrete mixing tank truck. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.hu198.com/