Automatic loading mixer is a mixing equipment that combines the functions of concrete truck and concrete mixing plant, integrates concrete loading, metering, mixing and discharging, and can realize concrete transportation and on-site concrete construction.

自動上料攪拌車的控制技術要求

Control technical requirements of automatic feeding mixer

1.各筒體，控制閥，電機按混凝土攪拌過程的要求運行，各筒體，控制閥，電機的控制準確，穩定，可靠。自上料混凝土攪拌車廠家它可裝運由攪拌廠生產的混凝土或按配比混合的骨料（砂、石子）、水泥和水，在運輸過程中，不斷對濕料慢慢攪拌，防止混凝土在運輸過程中初凝和離析。

1. Each cylinder, control valve and motor operate according to the requirements of concrete mixing process. The control of each cylinder, control valve and motor is accurate, stable and reliable. From the manufacturer of the loading concrete mixer truck, it can ship the concrete produced by the mixing plant (station) or the aggregate (sand, stone), cement and water mixed according to the proportion. During the transportation, the wet material is continuously mixed slowly to prevent the initial setting and segregation of the concrete during the transportation.

控制系統有自動和手動兩種工作方式，它們相互獨立，相互制約。

The control system has two working modes: automatic and manual, which are independent and restrict each other.

2.系統發展具有一個良好的抗干擾能力和完善的報警自保護管理功能；

2. The system development has a good anti-interference ability and perfect alarm self-protection management function;

3.通過與計算機通訊,可以進行顯示信息系統管理工作狀態、故障報警；

3. Through communication with the computer, it can display the working status and fault alarm of information system management;

它的主機多久清洗一次合適呢？

How often is it appropriate to clean its host?

一個工作周期內攪拌車主機系統至少應清洗1次。每天可以生產活動結束后，則應對攪拌車主機信息進行比較的清洗，方法是：在清洗服務過程中，將水及少許石子放進攪拌主機內通過攪拌5～10min，清洗后將機內物料管理全部清潔完，不得有積水、積料;停機后再沖洗以及管道，清潔完攪拌罐內外環境灰塵和粘附的混凝土。一般這種情況下，攪拌設備主機之間加水約150～180kg左右，其他產品型號選擇主機可據此分析增減，也可自備高壓水槍或者進行數據清理。

The mixer truck host system shall be cleaned at least once in a working cycle. After the production activities are finished every day, the main engine of the mixer truck shall be cleaned by comparing the information. The method is: during the cleaning service, put water and a little stone into the mixing main engine and mix for 5 ~ 10min. After cleaning, all the material management in the machine shall be cleaned without water and material accumulation; After shutdown, wash the and pipes, and clean the dust and adhered concrete inside and outside the mixing tank. Generally, in this case, about 150 ~ 180kg water is added between the main machines of JS1000 mixing equipment. The main machines of other product models can analyze the increase or decrease according to this, or provide their own high-pressure water gun or clean the data.

在沖洗攪拌主機料門時，應避免上部沖洗下的積料形成異物卡滯料門現象。攪拌過程中，若混凝土運輸車較長時間沒有到位(超過20～30min，尤其在夏季)，應加水對攪拌機進行簡易清洗。

When flushing the material door of the mixing machine, avoid the accumulation of material under the upper flushing to form the phenomenon of foreign matter blocking the material door. During mixing, if the concrete truck is not in place for a long time (more than 20 ~ 30min, especially in summer), add water to simply clean the mixer.

攪拌車設備正常生產期間，要定期檢查攪拌筒內及攪拌軸上混凝土的凝固情況，如有凝結應及時按要求進行人工鏟除。人工清理攪拌筒前，切斷電源、氣路，放凈余氣、鎖好控制室;人工清理攪拌筒時，嚴禁猛烈敲擊攪拌軸、攪拌臂及攪拌葉片。

During the normal production of mixer truck equipment, the solidification of concrete in the mixing drum and on the mixing shaft shall be checked regularly. If there is condensation, it shall be removed manually in time as required. Before manually cleaning the mixing drum, cut off the power supply and gas circuit, discharge the residual gas and lock the control room; When manually cleaning the mixing drum, it is strictly prohibited to knock the mixing shaft, mixing arm and mixing blade violently.

自動上料攪拌機用沖洗充電門，上部沖洗避免夾在充電門的現象形成的異物積累的材料時的攪拌主機設備?；旌线^程中，如果不再有在現澆混凝土卡車（超過20-30分鐘，尤其是夏天），水應加入攪拌機，便于清洗。

The automatic feeding mixer is used to flush the charging door, and the upper part is used to flush the mixing host equipment to avoid the accumulation of foreign materials caused by the phenomenon of being caught in the charging door. During the mixing process, if there are no more trucks in the cast-in-situ concrete (more than 20-30 minutes, especially in summer), the water shall be added to the mixer for easy cleaning.

以上就是自動上料混凝土攪拌罐車http://www.hu198.com為大家介紹的內容，感謝您在百忙之中查看我公司的信息內容，如果您想要了解的更多，歡迎您來電進行咨詢!

The above is the automatic feeding concrete mixing tank truck http://www.hu198.com Thank you for checking the information of our company in your busy schedule. If you want to know more, you are welcome to call for consultation!