1. During driving, it is found that the sliding distance of the mixer truck is significantly reduced. At this time, the drivers should check whether the tire pressure of the mixer truck meets the air pressure standard. If the tire is under inflated, the fuel consumption will also increase.

提示：適時為輪胎充足氣。

Tip: fill the tire in time.

2、檢查攪拌車輪胎的磨損程度，如果輪胎磨損嚴重時，就會經常出現打滑現象，增加耗油量。

2. Check the wear degree of the mixer tire. If the tire is seriously worn, it will often slip and increase the fuel consumption.

提示：必要時可更換的輪胎。

Tip: replace the tire if necessary.

3、在攪拌車行駛中或啟動時發現車輪有異常響聲，網友們應該及時檢查軸承及剎車系統是否有故障。如果車輪轉動不正常，就會影響攪拌車的車速，使油耗加大。

3. If abnormal noise is found on the wheels when the mixer is driving or starting, netizens should timely check whether the bearing and braking system are faulty. If the wheels rotate abnormally, it will affect the speed of the mixer and increase the fuel consumption.

提示：檢修軸承及剎車系統。

Tip: repair the bearing and brake system.

4、攪拌車離合器打滑會使發動機的轉數丟失。當您在急加速時發現攪拌車發動機轉速表增加很快，但車速增加卻很慢，這時可以判定是離合器打滑了。

4. If the mixer clutch slips, the number of revolutions of the engine will be lost. When you accelerate rapidly, you find that the engine tachometer of the mixer truck increases rapidly, but the speed increases slowly. At this time, you can judge that the clutch is slipping.

提示：需要更換離合器片，離合器壓盤和驅輪。

Note: the clutch plate, clutch pressure plate and drive wheel need to be replaced.

5、當攪拌車已經行駛二三十萬公里時，通常會出現汽缸壓力不足的現象，這時油耗會明顯增加。

5. When the mixer has been running for 200000-300000 km, the cylinder pressure is usually insufficient, and the fuel consumption will increase significantly.

提示：如果真的出現這種故障，那么攪拌車發動機就需要大修了。

Tip: if this kind of fault really occurs, the mixer engine needs to be overhauled.

6、當排氣管出現冒黑煙、油耗增D的現象時，需要檢查化油器。

6. When the exhaust pipe emits black smoke and the fuel consumption increases D, it is necessary to check the carburetor.

提示：如果化油器太臟可以用清洗劑直接向化油器進氣口噴一噴，若此時還冒黑煙，那只能把化油器拆開清洗了。

Tip: if the carburetor is too dirty, you can spray the cleaning agent directly into the carburetor air inlet. If there is still black smoke at this time, you can only disassemble the carburetor for cleaning.

7、如果攪拌車火花塞使用的時間太長，也會出現油耗加大的現象。因為攪拌車火花塞損壞會使點火的N量下降，車提速減慢，導致油消耗明顯增加。

7. If the spark plug of the mixer is used for too long, the fuel consumption will also increase. Because the damage of the spark plug of the mixer truck will reduce the amount of ignition N and slow down the speed-up of the truck, resulting in an obvious increase in oil consumption.

提示：應該換攪拌車火花塞了。

Tip: it's time to change the spark plug of the mixer.

8、當攪拌車的溫控開關和節溫器損壞時，會出現油耗增加的現象。因為攪拌車的溫控開關和節溫器損壞會使水溫降低，化油器不能正常工作，導致攪拌車油霧化不好，油耗量明顯增加。

8. When the temperature control switch and thermostat of the mixer are damaged, the fuel consumption will increase. Because the damage of the temperature control switch and thermostat of the mixer will reduce the water temperature and the carburetor can not work normally, resulting in poor oil atomization and obvious increase in oil consumption.