攪拌車減震器的保養應該注意什么?

 來源:http://www.hu198.com 日期:2021-03-08 發布人:admin
如果攪拌車的減震器失效或者出現問題,應首先查看減震器是否有漏油現象,用力按下保險杠,然后松開,假如攪拌車有兩到三次的騰躍,就說明減震器是好的。攪拌車在緩慢行駛中緊急制動,此時如果車輛的振動比較厲害,就說明減震器有問題,需要拆下減震器將其直立,并把下端銜接環夾在臺鉗上,用力拉壓減震桿數次,此時應有穩定的阻力,往上拉的阻力應大于向下的阻力,如果阻力不穩定或無阻力,可能是減震器內部缺油或閥門零件損壞,應終止修復或更換零件,并應立即送去維修。
If the shock absorber of the mixer fails or has problems, you should first check whether the shock absorber has oil leakage, press the bumper hard, and then release it. If the mixer has two or three jumps, it means that the shock absorber is good. The mixer is in emergency braking when it is running slowly. At this time, if the vibration of the vehicle is severe, it means that there is something wrong with the shock absorber. It is necessary to remove the shock absorber, erect it, clamp the lower connecting ring on the vise, and pull and press the shock absorber rod several times. At this time, there should be stable resistance. The resistance of pulling up should be greater than that of pulling down. If the resistance is unstable or there is no resistance, it may be the shock absorber In case of internal oil shortage or valve parts damage, repair or replacement of parts shall be terminated and sent to repair immediately.
攪拌車減震器漏油一般是以下幾個原因:
The reasons for oil leakage of mixer shock absorber are as follows:
1. 減震器內部的清潔度不夠好,有焊渣、鐵屑等雜物導致油封磨損。
1. The internal cleanliness of the shock absorber is not good enough, and there are welding slag, scrap iron and other debris, which lead to oil seal wear.
自上料混凝土攪拌罐車
2. 減震器的工作條件比較惡劣,外部的泥沙等雜物進入油封,導致其磨損漏油。
2. The working condition of the shock absorber is very bad, and the foreign matters such as sediment enter into the oil seal, resulting in wear and oil leakage.
3. 減震器油封的唇口老化,失去了密封的功能。
3. The lip of the oil seal of the shock absorber is aging, and the sealing function is lost.
4. 可能是在噴底盤裝甲的時候,減震器沒有遮擋好,裝甲附在減震器活塞桿上導致油封磨損而漏油。
4. When spraying chassis armor, the shock absorber was not covered well, and the armor was attached to the shock absorber piston rod, causing oil seal wear and leakage.
5. 控制活塞運動的支桿需要在金屬管的一端延長出來,所以這個部位必須得密封嚴密,一般的漏油都和密封不嚴有直接關系的。
5. The supporting rod to control the movement of the piston needs to be extended at one end of the metal tube, so this part must be tightly sealed. Generally, the leakage is directly related to the poor sealing.
6. 一般攪拌車的液壓的減震器漏油就說明它的使用年限已到。
6. The oil leakage of the hydraulic shock absorber of the general mixer indicates that its service life has come.
今天是小編給大家介紹的自上料混凝土攪拌罐車內容,更多的精彩內容請?jiān)敿?xì)的關注我們的網站:http://www.hu198.com,后續內容我們會定期的進行更新!
Today is the content of Zhongke Jufeng concrete mixer introduced by Xiaobian. For more wonderful content, please pay more attention to our website: http://www.hu198.com We will update the follow-up content regularly!